#Honda atc 350x cam chain block install

It's just apparently not enough pressure to quiet them down.įeel like I'm about to start running in circles. It IS also getting oil to the head, the cam and rockers are always nice and wet and there's oil sitting under them.

It's nice and full of fresh clean oil so that aint it. Ran the valves a bunch of times hoping the valve clatter was due to loose valves, no dice. Just disassembled and cleaned the oil pump, tolerances are awesome, and relief valve is perfectly functional. Things I've checked: Oil pickup screen is fine, nothing plugging it up. That was the only thing that got changed when I had the head off (other than the cyl2 exhaust valve).

#Honda atc 350x cam chain block install

I'm pretty sure its not possible to install the HG upside down, and from what I can see, it looks like the HG is fine and in the right spot. Valves clatter and dash gauge reads nothing at idle and very slowly rises up a bit if you keep the engine spinning at ~2500rpm for awhile. Lapped in a new valve, new head gasket, all that good stuff. I was still driving the truck at the time, and from what I can tell it burned an exhaust valve from running too lean after the delete. The story: Did an EGR and A/C delete when I put a new 22re in my truck about 5000ish miles ago.